Multiple Outlet Applicators

The ELECTROMATIC XX automatic applicator head series is used for applications requiring multiple parallel lines or dots of hot melt or similar thermoplastic materials, where accurate placement and amount of material is important.

The ELECTROMATIC XXV automatic applicator head series is used in the application of cold materials.

The proven design principles of the patented ELECTROMATIC head have been applied to multiple outlet applicators to bring to the operation the advantages that ELECTROMATIC users have enjoyed for over thirty years.

HIGH SPEED OPERATION….each outlet directly controlled by its own solenoid coil, with the shut off needle unhindered by any packings. UNSURPASSED ACCURACY…..responds to electrical signals, immediately and repeatedly.. Fire each outlet individually or all outlets together. Use sophisticated controls or simple switches. MINIMUM MAINTENANCE…..one moving part. No dynamic seals to wear or replace. INSTALLATION FLEXIBILITY…..standard models available with two or more outlets on various centers. Use single or multiple orifice tips. Side outlet tips for top and bottom applications. COST COMPETITIVE…..no air valves or piping required. Single hose supplies all outlets.

TYPICAL USE

The ELECTROMATIC XX is intended for use with hot melt adhesives, waxes, sealants, solders, and other thermoplastic materials, or generally any material whose application is enhanced by the controlled application of heat. Its ability to apply multiple lines or small accurate dots in repeatable patterns makes it ideal for use in applications where space or cost render the use of multiple guns impractical, and where precise control is required.

GENERAL DESIGN

Fluid is dispensed when any of the built-in solenoid coils are energized by an electrical signal, moving the needle assembly away from the valve seat. The plunger has no seals or packings to inhibit its movement, and thus responds uniformly, providing accurate repeatability for every actuation. This ensures that the amounts dispensed will always be alike for the same time setting. Material may be delivered in almost microscopic sized dots, thin lines, heavy beads, or generally in almost any pattern desired. Precision machining eliminates the need for needle adjustment with all outputs dispensing equal amounts.

LOW MAINTENANCE

The exterior housing is of plated steel, able to withstand the abuse that may be experienced in some extreme installations. There are no moving seals or packings to cause leaks, binding, or require adjustment and replacement. (Seals are usually the major source of problems with most ordinary applicators.) There are fewer parts than most applicator heads…and only one moving part.

Air Operated

Air Dispersed

 

 

Cold Hoses

Heated Hoses

Pattern Controls

Copyright Spraymation Inc., 1998, all rights reserved.
Spraymation, electromatic, thermopulse, and compuspray are all registered trademarks of Spraymation Inc.